|
發表於 2025-9-26 13:14:58
|
顯示全部樓層
本帖最後由 t1174 於 2025-9-26 13:18 編輯
方便大家更了解一點. Ben Sir 在片中提到 MSB, 因此我就去找找, 找到如下比較官方的說明:
https://forum.msbtechnology.com/t/about-msb-fiber-connections/926
當中也說了好多, 還有說好處壞處點用同點選擇....睇完我有點想轉回一般 FIBER, 就算我只是用 Lumin L2.
Every time you remove and insert the cabling, you are wearing out a direct connection on the PCB motherboard itself. That means the wear point shifts from the removable and replaceable SFP modules to the motherboard. If worn out to an unreliable state, the motherboard will need to be replaced on both the Digital Director and Analog Converter. This will NOT be a warranty repair.
The sockets are only rated for a few hundred plug cycles. Depending on the SFP module, it could be as few as 200 to 300 insertions. For any home installation, this will not be a concern. If the system is installed and infrequently moved you will never run into this issue.
This is a severe warning for dealers, demos, and the enthusiast who wants to constantly experiment and A/B cabling in their system. It is a lot of insertions, but we want to make sure you are very aware of the potential cost when and if there is a related failure due to excessive insertions. We don’t want to scare you off from trying AOC, as the sonic benefits are well worth it for long term use. |
|