|
發表於 2017-11-20 22:07:21
|
顯示全部樓層
High Level Inputs This feature is included for convenience when needing to connect the E-Sub to a receiver or integrated amplifier that only offers speaker level outputs. It is not the preferred method when a line-level signal is available. To use the “High Level Inputs” feature, simply connect the speaker outputs of the receiver or integrated amplifier to the “High Level Input” plug of the E-Sub, in parallel with the main speakers. The main speakers will remain full-range in this application and their sound will not be affected by the connection to the E-Sub. The “High Level Input” consists of an input connector and removable plug with captured-wire receptacles. Standard speaker cable, up to 12 AWG (3 mm2), can be used and connected to the removable plug by backing out each set screw, inserting the bared end of each speaker wire, taking care not to short any wire to another, and tightening the set screw. Connections are as follows: “High Level Input” Connector (from left to right): 1: Right Channel Negative 2: Right Channel Positive 3: Left Channel Negative 4: Left Channel Positive Input Impedance: 4.3 kΩ
|
|