Anthem release v02062 for AVM60/MRX X20 firmware DTS:X support

chhanthony

Finally..................DTS:X is arrived!!!

Changes:


V02067_2016_12_14.fw:


1.  (AVM 60 and MRX 1120/720) Added dtsX decoding and Neural:X upmixing, including compatibility with Dolby Enabled upfiring speakers.

Info:

DTS:X dialog level control - this applies only to dtsX sources making use of the function.  To raise or lower the level of the dialog (actor voices), use the PG/PR up/down buttons on the remote. The range is 0-6 dB, default 3 dB.

DTS Neural:X uses all speakers in a DTS:X system for an immersive audio experience, creating separation by placing sounds at different points in the sound field. This mode does not apply to DTS:X Master Audio, DTS:X, Dolby Atmos, Dolby TrueHD, and Dolby Digital Plus sources

DTS Neural:X setup (input setup menu) - When the source is a DTS stream, Direct mode plays the audio channels as they were recorded, whereas Non-Direct mode (default) adapts the audio to your speaker layout if it is different from the content creator’s.

2.  Updated HDMI code library.

3.  Improvements to CEC power-on.

4.  Headphone downmix wasn't working properly - fixed.

5.  Fix for odd input setup display when exactly 8 inputs were configured.

6.  (AVM 60 and MRX 1120/720) If Dolby Volume was enabled before running ARC, height channels weren't producing test tones - fixed.

7.  Fix for too many characters in IP feedback.

8.  Removed Control4 ID Tx from setup menu.

















Also updated ARC-2 v1.5.4872:

1. Improved subwoofer cutoff frequency selection for cases with extreme response dips.

2. Fixed issue where ARC could crash if connection attempts were not acknowledged.

3. Graph range increased to 20 kHz, but note that as always measured result above 5 kHz is often unreliable.

4. Q range when loading certain older files adjusted for compatibility.  If you are loading a file that was created quite a while ago, clicking Targets, Auto-Detect, OK, Calculate, Upload is recommended before uploading the file.

5. Changes related to in-development powered speakers which use ARC.

download address:

http://www.anthemav.com/support/latest-software.php

fishbone8822

Good News
thx share

wildmanhk

好消息，期望餅主攪個Anthem Vs Arcam大比併