XLR cable For C50 & MC452

spherez

Hi Ching,

I am planning to buy C50 to match my MC452 now
I am using AFA Silver Lance to connect pre-amp (Ayre K5x) with power amp (MC452) now. Does it still be suitable for C50? If no, any recommendation of XLR cable for C50 and MC452?
My budget is around 6K.
Thank you in advance!

supercow

you can try racewong's nordost Valkyria. I'm now using nordost vahalla for c500t -> mc452..very good result.

spherez

Hi Supercow,

I had read your posts and know that you used Madison E3 1 for your system before. any problem for it?
Thank you again.

racewong

spherez 發表於 2012-8-3 10:46
Hi Supercow,

I had read your posts and know that you used Madison E3 1 for your system before. any  ...

師兄, 你用到C50+452, 條IC一定唔慳得呀!

超牛就係一個好例子!

racewong

supercow 發表於 2012-8-3 10:43
you can try racewong's nordost Valkyria. I'm now using nordost vahalla for c500t -> mc452..very good ...

nordost Valkyria?! 比我玩多幾個星期先啦.

supercow

spherez 發表於 2012-8-3 10:46
Hi Supercow,

I had read your posts and know that you used Madison E3 1 for your system before. any  ...

no problems.....just 身痕...

spherez

Hi Racewong ching,
I know..but no more $$ to buy expensive one after bought C50

Hi Supercow,
Thanks for your advice. The nature Siltech 180ix and Madison E3 1 seem to be similar. Does 180ix be match for C50 and MC452?

supercow

i tested both Siltech 180ix and Madison E3 1.......Madiaon better in my system.

spherez

Thank You ALL Ching!!

kenho

willip

I am using Madison for my C50 to 275 now.
I am still not satisfied with the bass.

kenho

willip 發表於 2012-10-24 11:18
I am using Madison for my C50 to 275 now.
I am still not satisfied with the bass.

Dear 師兄,
低頻部份其實是較難調較的, 因為涉及太多不同類型的物理因素影響 , 如線材本身不利低頻屬減肥一族, 而又如落腳位諧振干擾、 房間駐波干擾底消、相差相減、迅間供電源峰值不足、瀘波電流不足, 甚至器材不匹配等等..... 也是導致沒有正常低頻效果之元凶所在, 就算任憑小弟三十多年鑽研 Hi Fi 經驗, 也不能紙上談兵, 得也必須實地測量按步就班的去慢慢解決。

米糕脏了

XLO R3 balance cable is enough

kenho