找回密碼
 新用戶註冊
搜索
熱搜: hifi av 音樂
查看: 15214|回復: 53

[產品] Mcintosh MEN220

[複製鏈接]
發表於 2013-5-11 22:46:25 | 顯示全部樓層 |閱讀模式
Ken 兄:
MEN220是否只能用於前後級上,合拼機是不合用嗎?
如不是Mcintosh的前後級,能否合用?
如也能用在別品牌的前後級上,效果會否不完全配合而差點呢?
勞煩解答,謝!

Thx
 樓主| 發表於 2013-5-12 11:20:30 | 顯示全部樓層
如能合拼機上使用,連接方法又如何?
是否Input入source(cd/dac), output HF/LF, 應選那一個?
回復

使用道具 舉報

發表於 2013-5-12 13:07:20 | 顯示全部樓層
看了说明书,没有用在合并机的,但可以在其他牌子的前后级使用.
回復

使用道具 舉報

 樓主| 發表於 2013-5-12 15:51:48 | 顯示全部樓層
原來如此,多謝lixr168師兄査解!
回復

使用道具 舉報

 樓主| 發表於 2013-5-13 16:19:46 | 顯示全部樓層
聽說別品牌可用於合并机上, 是用tape in 和 tape out 代替 pre-amp 和 power amp...
回復

使用道具 舉報

發表於 2013-5-18 02:20:52 | 顯示全部樓層
I am a current user of this wonderful gear, here is for your reference from other website.

The men220 can be inserted in the signal path in a processor or tape loop of an integrated amp. For instance, in the case of the integrated MA6600 amplifier or similar. You would remove the preamp/amp jumpers on the rear of the MA6600 and insert the MEN220 into the signal path there.
__________________

評分

1

查看全部評分

回復

使用道具 舉報

發表於 2013-5-18 13:55:31 | 顯示全部樓層
Dear 師兄,
問:MEN220是否只能用於前後級上,合拼機是不合用嗎?
答:MEN220 不單只可用於前去後級之間,亦可以用在 音源與擴音器之間,若合併機設有抽頭 Jumper 就可以由 pre-out --> amp input 之間使用。

問:如不是Mcintosh的前後級,能否合用?
答:當然可以,其適合用在所有擴音器與音響產品之上呢

問: 如也能用在別品牌的前後級上,效果會否不完全配合而差點呢?
答:理論上是沒多大的問題,而且效果亦會有預期的理想,絕對好用
回復

使用道具 舉報

發表於 2013-5-18 14:09:04 | 顯示全部樓層
THX 發表於 2013-5-12 11:20
如能合拼機上使用,連接方法又如何?
是否Input入source(cd/dac), output HF/LF, 應選那一個?
...

Dear 師兄,
在 MEN220 中有兩種 Input 之設定:
1. 是 source(cd/dac)-->MEN220-->amp.
而 output 1, output 2  都可設定為全頻輸出來配合接駁。

2. 是 pre-amp-->MEN220-->power amp.
在一般接駁一台兩聲道 power amp 或 一對 mono block 之情況下,把 output 1、2 設定為全頻輸出,接駁其中一組也是可以的。
若是以 bi-amp 電分輸出的玩法,output 1 設定為 High pass, output 2 則設定為 Low pass 即可。(當然亦要設定好相關的分頻點呢)
回復

使用道具 舉報

發表於 2013-5-18 14:12:26 | 顯示全部樓層
THX 發表於 2013-5-13 16:19
聽說別品牌可用於合并机上, 是用tape in 和 tape out 代替 pre-amp 和 power amp...  ...

Dear 師兄,
tape in 和 tape out 是早期機種用作卡式帶的錄音導航,這是不能切入其他器材的。
回復

使用道具 舉報

 樓主| 發表於 2013-5-18 14:25:39 | 顯示全部樓層
mlfan2012 發表於 2013-5-18 02:20
I am a current user of this wonderful gear, here is for your reference from other website.

The men ...

Thanks mlfan2012 big brother!
Can you share the feeling and the different between Global, Focau and Voicing?
回復

使用道具 舉報

 樓主| 發表於 2013-5-18 14:45:33 | 顯示全部樓層
kenho 發表於 2013-5-18 14:09
Dear 師兄,
在 MEN220 中有兩種 Input 之設定:
1. 是 source(cd/dac)-->MEN220-->amp.

多謝Kensir解說!
但對於合拼AMP的接法#1
source RCA out -->  input - MEN220 - output 1( SET TO FULL RANGE) --> amp 的任何 input  
這樣就可以嗎?
如不原全正確,請詳盡些解說吧!謝!
回復

使用道具 舉報

 樓主| 發表於 2013-5-18 15:01:55 | 顯示全部樓層
kenho 發表於 2013-5-18 14:12
Dear 師兄,
tape in 和 tape out 是早期機種用作卡式帶的錄音導航,這是不能切入其他器材的。  ...

關於Tape in / Tape out 不能切入,有些迷惑

我是用Diablo的••••
我理念上的接法是

Diablo RCA tape out --> input - MEN220 - output 1 (set to full range) --> Diablo tape in
or
Diablo tape out = pre-out --> MEN220 --> Diablo input 3 (set to av by pass)

(因Diablo 的input 3 是指定的av by pass 把Diablo 當作後級使用的!)

先多謝Ken Sir多多賜教!
回復

使用道具 舉報

 樓主| 發表於 2013-5-18 17:12:52 | 顯示全部樓層
在想MEN220就像一台equalizer,不是就把它tape in / tape out 就是嗎?
回復

使用道具 舉報

發表於 2013-5-20 13:49:33 | 顯示全部樓層
THX 發表於 2013-5-18 14:45
多謝Kensir解說!
但對於合拼AMP的接法#1
source RCA out -->  input - MEN220 - output 1( SET TO FULL ...

Dear 師兄,
Yes , 全中呢
回復

使用道具 舉報

發表於 2013-5-20 14:05:57 | 顯示全部樓層
THX 發表於 2013-5-18 15:01
關於Tape in / Tape out 不能切入,有些迷惑

我是用Diablo的••••

Dear 師兄,
的確是有點不了解,因為通常本機之 Tape out / Tape in 是同屬一個  source 檔位,因此不能同時自出自入,當然亦有例外,因此不妨先試試再下定論 。  反之 Pre- out / Main In or amp In 則是本機的兩個不同檔位,可分離作獨立操作,相對很像一套裝在同一機箱中的前後級,所以當使用 MEN220 之時候其接駁與設定也和正規的前後級一樣,效果當然可以肯定呢
回復

使用道具 舉報

發表於 2013-5-20 14:09:36 | 顯示全部樓層
THX 發表於 2013-5-18 17:12
在想MEN220就像一台equalizer,不是就把它tape in / tape out 就是嗎?

Dear 師兄,
MEN220 本身亦是一台 EQ ,不妨一試
回復

使用道具 舉報

 樓主| 發表於 2013-5-22 14:42:09 | 顯示全部樓層
Thanks Ken Sir,
Tape in and out did not work...
Can only use source to MEN220 directly!
Anyway thanks!!
回復

使用道具 舉報

發表於 2013-5-23 11:08:28 | 顯示全部樓層
THX 發表於 2013-5-22 14:42
Thanks Ken Sir,
Tape in and out did not work...
Can only use source to MEN220 directly!

Dear 師兄,
請勿客氣 ,正如先前所說,Tape in/ Tape out 的使用方法多數是不行的,那只能使用原先的方法接駁才可正確使用 ,謝謝你的支持呢
回復

使用道具 舉報

發表於 2013-5-30 16:49:28 | 顯示全部樓層
THX 發表於 2013-5-18 14:25
Thanks mlfan2012 big brother!
Can you share the feeling and the different between Global, Focau an ...

Sorry for the delay. Been busy traveling around. Not much time staying home for my hobby.

As far as I know, the global setting is for multiple listeners (party) in the room where everyone share same sonic experience from playing back songs , in short there isn't much a certain king spot for one person. Since I mostly listen to music myself, thus using "Focal" (reach over 90-95% room knowledge in 4-5 mic positions) for my king spot. Speaking of Voicing, I set to "Normal", but all depends and what to listen. Not to mention the voicing tool where we can create our own custom frequency curves through a computer and be able to install back to the MEN220 for personal sonic preferences.

For cross-over mode, depending on what speakers to be used, I manually set in hi-lo frequency for roll in and off as well as timing delay in order to blend in my electrostatic panels speakers with pair of subwoofers. It works great for me. Hope this help.

評分

1

查看全部評分

回復

使用道具 舉報

發表於 2013-5-31 10:27:55 | 顯示全部樓層
mlfan2012 發表於 2013-5-30 16:49
Sorry for the delay. Been busy traveling around. Not much time staying home for my hobby.

As far  ...

Dear 師兄,
相信你現在的設置效果應該是十分不錯呢 ,而且 MEN220 也是相當好用,不但可以處理房間不利聲場,又可以幫你手好好管理音頻分配,發揮器材潛在實力
回復

使用道具 舉報

您需要登錄後才可以回帖 登錄 | 新用戶註冊

本版積分規則

Archiver|小黑屋|聯絡我們|刊登廣告|Hiendy.com 影音俱樂部 一個屬於音響愛好者的家

GMT+8, 2024-3-29 19:32 , Processed in 0.041179 second(s), 18 queries .

Powered by Discuz! X3.5

© 2001-2023 Discuz! Team.

快速回復 返回頂部 返回列表