|
|
發表於 2014-6-28 07:22:18
|
顯示全部樓層
本帖最後由 CKKeung 於 2014-6-28 07:52 編輯
The leading-edge technological advancements implemented on the A1 were further refined, among others is the ExactBias circuitry and a finer loudspeaker matching.
Specified at 200W RMS into 8Ω in monaural mode, 2x 200W RMS into 8Ω in bi-amplification mode and 700W RMS into 8Ω in bridge mode.
The M1 houses a dedicated 2200VA power transformer.
Modularity
• Monaural mode
• Bi-amplification mode
• Bridge mode
Power Supply
• Dedicated 2200VA power transformer mounted on silentblocks for minimal vibration transmission
• Magnetically and electrostatically shielded transformers
• Hyper fast soft recovery diode bridge rectifier
• 4-pole 100’000uF reservoir and filtering capacitors
• Dedicated 20A mains socket for audio power section
Full Analog Signal Path
• Pure class A, fully symmetrical design
• Fully discrete, ultra low noise, high slew rate design
• No capacitor in the audio signal path
• No output relay
• Argento loudspeaker binding posts and internal wiring
Gain Trimming
• Trim gain to accommodate loudspeaker sensitivity
• 24dB range in 0.5dB steps
Global Versus Local Feedback Ratio
• Ranging from 0% – local feedback only – to 100% – global feedback only – in 10% steps
• Feedback can be set on the fly from the user interface
• Independent feedback ratio in bi-amplification mode
Output Stage ExactBias
• Amplifier output stage and listening room temperature independent bias
• Patent-pending ExactBias regulation circuitry
Protections
- Non-invasive output stage voltage, current and temperature monitoring
- Protection procedures in case of output short circuit, open connection or excessive temperature
- Instantaneous output power and temperature can be displayed on the front panel
|
評分
-
1
查看全部評分
-
|