找回密碼
 新用戶註冊
搜索
熱搜: hifi av 音樂
查看: 14352|回復: 20

[CAS] 用兩件 Cisco 2960 代替 Fiber Box?

[複製鏈接]
發表於 2018-6-2 08:15:44 | 顯示全部樓層 |閱讀模式
基本上就係 Naim 嘅用家發現咗 Cisco 2960 好得,跟住有一位師兄就照辦煮碗:

https://www.computeraudiophile.com/forums/topic/37034-smps-and-grounding/?page=38&tab=comments#comment-816134
FWIW just went from a shunted Netgear with TP-Link FMC’s post into microRendu, to a pair of Cisco 2960-8TC-L’s picked up for $29/ea on ebay, along with a couple of Cisco SFPs for $5/ea and LC-LC fiber cable to connect the two. The Cisco’s are fanless and have internal SMPS’s so was able to rid myself of some linear power supplies/iFi’s as well. Server and internet input (from another switch) into the first one; Ghent JSSG ethernet cable into rendu out of the second. Sound is incredible, full and weighty with deep bass compared to the consumer units. IMO this is the way to go, and has been all the rage over on the Naim forum for some time. These commercial Cisco’s can be picked up cheap as chips. Only issue is the switches have to be near the hifi (as the crow flies) but there will always be payoffs, and I’m pretty sure these leak a lot less than the consumer units.
SERVER CLOSET (in office directly below living room stereo):NUC 7i5BNH with Roon ROCK and OWC external 2.5" HD (HDPLEX 100 powering both)>Cisco 2690 switch>optical fiber>LIVING ROOM:Cisco 2690 (optical fiber in)>Ghent Audio JSSG Cat 6a cable>Sonore microRendu 1.4> (<DIY Supra Cat8 DC cable<Uptone LPS-1<Uptone LPS 1.2 charger) Uptone USPCB>Naim DAC V1>Witchhat DIN>Naim NAP 110>Chord Rumor 2>Rega RX3’s.OFFICE:Cisco 2690 switch>basic cat 6a>Naim Unitiqute V1>NACA5>KEF Ls50's.


呢度有 Cisco 2960 大戰 Paul Pang TCXO 嘅報告:

http://forums.naimaudio.com/topic/cisco-2960-8tc-vs-paul-pang-tcxo

其他報告:

http://forums.naimaudio.com/topic/cisco-switch
http://forums.naimaudio.com/topic/cisco-2960-set-up
http://forums.naimaudio.com/topic/cisco-2960-router-confusion
http://forums.naimaudio.com/topic/cisco-2960-recommendation
http://forums.naimaudio.com/topic/cisco-catalyst-ws-c2960-8tc-l-2960
http://forums.naimaudio.com/topic/cisco-router-to-match-cisco-ws-c2960-8tc-l



二手嘅公價係 150 人仔,如果幫襯個別賣家就平少少:

思科CISCO WS-C2960-8TC-L 8百兆口 1千兆 1个SFP口 带管理交换机
https://item.taobao.com/item.htm?id=528033982669
原装思科CISCO WS-C2960-8TC-L 8口百兆 1个千兆 管理交换机现货
https://item.taobao.com/item.htm?id=530527281411
思科CISCO WS-C2960-8TC-L 8口百兆 1个千兆 管理交换机 现货
https://item.taobao.com/item.htm?id=532670895302
思科 Cisco Catalyst WS-C2960-8TC-L S 8口百兆+千兆+千兆光口
https://item.taobao.com/item.htm?id=553663017894
思科Cisco WS-C2960-8TC-S/L 8口百兆+1千兆/SFP以太网交换机
https://item.taobao.com/item.htm?id=565121354957
思科 CISCO WS-C2960-8TC-L 8口交换机
https://item.taobao.com/item.htm?id=566665950723



Cisco Gigabit Ethernet Transceiver Modules Compatibility Matrix
https://www.cisco.com/c/en/us/td/docs/interfaces_modules/transceiver_modules/compatibility/matrix/GE_Tx_Matrix.html#_Toc515202742

GBIC 就勁平,二手最平就 14 人仔再加運費,全新最平就 45 人仔包郵,不過就唔知有無 A 貨咁解:

思科CISCO GLC-SX-MM 850nm 千兆多模光模块用于3560 3750等
https://item.taobao.com/item.htm?id=14116090991
全新现货 CISCO/思科 GLC-SX-MMD= 千兆多模光纤模块 ,850nm LC
https://item.taobao.com/item.htm?id=45721289209
CISCO/思科 GLC-SX-MMD= 千兆多模光纤模块 ,850nm 全新现货
https://item.taobao.com/item.htm?id=558697595927

條光纖線就自己搵一搵。

評分

1

查看全部評分

發表於 2018-6-2 08:27:27 | 顯示全部樓層
本帖最後由 diamondblack 於 2018-6-2 16:09 編輯

其實係同一個道理,只不過你唔同electronics唔同設計出嚟效果有分別高低係理所當然。

Fiber Box拆開咪又係兩個並聯嘅乙太網光纖轉換器模組,兩條乙太網線,一條光纖,同線性供電,所有嘢都可以off-the-shelf買到,質素、價錢高低按用家意願同能力選擇就可以了。

評分

4

查看全部評分

回復

使用道具 舉報

發表於 2018-6-2 11:08:58 | 顯示全部樓層
diamondblack 發表於 2018-6-2 08:27
其實係同一個道理,只不過你唔同electronics唔同設計出嚟效果有分別高低係理所當然。

Fiber Box拆開咪又係 ...

光纎隔離這原理用於 network CAS 是ㄧ定 works 的。

不過小弟也給個小提示吧 : fiberbox 的預算和用料不能太差, 否則結果是會適得其反的。

評分

2

查看全部評分

回復

使用道具 舉報

發表於 2018-6-2 11:10:53 | 顯示全部樓層
CKKeung 發表於 2018-6-2 11:08
光纎隔離這原理用於 network CAS 是ㄧ定 works 的。

不過小弟也給個小提示吧 : fiberbox 的預算和用料不 ...

我就黎有得試新版既FIBERBOX了...
回復

使用道具 舉報

發表於 2018-6-2 12:46:16 | 顯示全部樓層
CKKeung 發表於 2018-6-2 11:08
光纎隔離這原理用於 network CAS 是ㄧ定 works 的。

不過小弟也給個小提示吧 : fiberbox 的預算和用料不 ...

我好贊同,因為我都試過,個分別真係好大好大。
回復

使用道具 舉報

發表於 2018-6-2 12:46:57 | 顯示全部樓層
racewong 發表於 2018-6-2 11:10
我就黎有得試新版既FIBERBOX了...

恭喜曬你
回復

使用道具 舉報

發表於 2018-6-3 08:08:14 | 顯示全部樓層
我呢件會否誤打誤撞中咗

用咗成年無比較過, 諗住慳d接駁位同火牛, 可能亦減了 noise leakage 機會



輸出端我用普通單輸出 FMC, 我估少 lan port 可能少 d noise
回復

使用道具 舉報

發表於 2018-6-3 15:27:35 | 顯示全部樓層
paulkwan 發表於 2018-6-3 08:08
我呢件會否誤打誤撞中咗  

用咗成年無比較過, 諗住慳d接駁位同火牛, 可能亦減了 noise leakage  ...

呢類機其實比企業用,好多功能,就因為功能多,零件也多,自已用過兩隻唔同牌子類似的機,效果冇普通的1光4电或1光8电的media converter好.
回復

使用道具 舉報

發表於 2018-6-5 09:42:08 | 顯示全部樓層
搵部有fibre 入嘅 streamer 就煩少好多野
回復

使用道具 舉報

發表於 2018-6-5 12:42:16 來自手機 | 顯示全部樓層
三文魚腩 發表於 2018-6-5 09:42
搵部有fibre 入嘅 streamer 就煩少好多野

請問邊部 streamer 有?
回復

使用道具 舉報

發表於 2018-6-5 12:47:46 | 顯示全部樓層
PhantomGTR 發表於 2018-6-5 12:42
請問邊部 streamer 有?

LUMIN X1 有sfp module 入

Screen Shot 2018-06-05 at 12.46.29 PM.png

評分

1

查看全部評分

回復

使用道具 舉報

發表於 2018-6-5 12:49:16 | 顯示全部樓層
PhantomGTR 發表於 2018-6-5 12:42
請問邊部 streamer 有?

Lumin 新款旗艦 X1

評分

1

查看全部評分

回復

使用道具 舉報

發表於 2018-6-5 18:20:43 | 顯示全部樓層
三文魚腩 發表於 2018-6-5 12:47
LUMIN X1 有sfp module 入

回復

使用道具 舉報

發表於 2018-6-5 18:21:40 | 顯示全部樓層

太好了!!
回復

使用道具 舉報

發表於 2018-6-5 18:24:15 | 顯示全部樓層
三文魚腩 發表於 2018-6-5 12:47
LUMIN X1 有sfp module 入

Lumin確係值得驕傲嘅香港品牌,產品用心有誠意
回復

使用道具 舉報

發表於 2018-6-5 21:04:06 來自手機 | 顯示全部樓層
部x1 賣街了?幾錢?
回復

使用道具 舉報

發表於 2018-6-5 21:33:14 | 顯示全部樓層
本帖最後由 三文魚腩 於 2018-6-5 21:51 編輯
Midnighteye 發表於 2018-6-5 21:04
部x1 賣街了?幾錢?


未。香港未有價。大概下個月會有貨。
回復

使用道具 舉報

發表於 2018-6-6 01:39:00 來自手機 | 顯示全部樓層
http://www.luminmusic.com/lumin-x1.html
回復

使用道具 舉報

發表於 2018-6-6 07:47:48 | 顯示全部樓層
回復

使用道具 舉報

發表於 2018-6-6 13:43:40 | 顯示全部樓層
三文魚腩 發表於 2018-6-5 21:33
未。香港未有價。大概下個月會有貨。

唔知會唔會出齋Transport呢?
回復

使用道具 舉報

您需要登錄後才可以回帖 登錄 | 新用戶註冊

本版積分規則

Archiver|小黑屋|聯絡我們|刊登廣告|Hiendy.com 影音俱樂部 一個屬於音響愛好者的家

GMT+8, 2024-4-24 14:08 , Processed in 0.043316 second(s), 19 queries .

Powered by Discuz! X3.5

© 2001-2023 Discuz! Team.

快速回復 返回頂部 返回列表