|
DS AUDIO DS003 OPTICAL CARTRIDGE
The new DS Audio DS003 optical cartridge system has been optimized, by implementing an independent LED and photo-detector arrangement for the left and right channels. As a result the cartridge output voltage has greatly increased from 40mV to 70mV. Despite this increase in output, the signal to noise ratio that DS Audio optical cartridges are known for has not been compromised.
The DS Audio DS003 cartridge offers a greatly improved S/N ratio when compared to its stable mates, resulting in an even lower noise floor. In addition to this, the new independent design of the DS003 cartridge has made it possible to eliminate crosstalk, greatly improving left and right channel separation (in particular the high frequency separation has improved by10dB in comparison to its DS Audio predecessors).
WEIGHT REDUCTION
There has been a 50% weight reduction in DS Audio’s new reshaped, solid beryllium shading plate. The implementation of independent left and right channel LED’ s allows for the positioning of the optical system to be optimized as well as necessitating the use of a new shading plate that has been significantly reduced in size compared to the earlier designs. In addition to this reduction in size, the material used to produce the shading plate has changed from aluminium (as used in the second generation cartridges) to 99.9% pure beryllium. As a result of this, DS Audio succeeded in reducing the weight of the shading plate by more than 50%, from 1.56mg to 0.74 mg. This is less than 1/10th of the mass when compared to the core and coil system found in a typical MC (moving coil) cartridge and further improves one of the key advantages of DS Audio’s optical cartridge technology, which is a very low effective mass.
ALUMINIUM CANTILEVER
The DS AUDIO DS003 cartridge features a combination of an aluminium cantilever with a line contact stylus. The cartridge is made by aluminium and the body structure has been designed in such a way as to promote maximum rigidity. In addition to these features, the DS003 utilizes internal wiring 1.6 times thicker than used in the second generation cartridges in order to reduce impedance.
EQUALIZER
Compared to the DS Audio DS002 equalizer, the thickness of the circuit board has been changed from 1.6 mm to 2.0 mm, and the thickness of the copper foil has been changed from 35 µ to 70 µ. In addition, the DS003 equalizer allows you to select the cutoff frequency for the low-frequency range from four types, allowing you to select an output that better matches your system.
SPECIFICATIONS
DS 003 Optical Cartridge
Signal output: Photo-electric Conversion
Channel separation: 27db (1KHz)
Weight: 7.7g
Output signal level: 60mV (1kHz cartridge output)
Cantilever: Aluminium
Body material: Aluminium (A5052)
Cantilever holder material: Stainless
Needle pressure: 2.0g~2.2g (2.1g is recommended)
Stylus: Line contact |
|