兩隻Subwoofer 點擺法好?

herman

係呀! 諗住做條一開二既xlr, 又驚開一隻唔開一隻有影響

所以一隻拖一隻係最好, 拾仔說明書都係咁講

herman

Connecting multiple subwoofers
1. From the processor or receiver's subwoofer output (often marked as “subwoofer
out”, “Sub out” or “LFE”), connect a mono RCA-to-RCA or XLR-to-XLR cable to the
INPUT of the first subwoofer in the daisy chain. This is now the Master subwoofer.
2. Set the Master subwoofer's Input Function switch to the Master position.
3. From the Master subwoofer's Processed Out To Slave output, connect a mono
RCA-to-RCA or XLR-to-XLR cable to the next subwoofer's (Slave) INPUT.
4. Set the Slave subwoofer's Input Function switch to the Slave position.
5. Any subsequent Slave subwoofers can be connected in a daisy chain style, going
from the Processed Out To Slave output to the next Slave subwoofer's INPUT.

herman

After all connections are made, connect the supplied mains leads to the
subwoofer's IEC power sockets and a mains outlet.
Note
• The Input Function switch of each subwoofer operated as a Slave must be set to
the Slave position.
• When using multiple subwoofers in a Master-Slave setup, it is recommended that
the subwoofers are all the same model.
• If you wish to use multiple subwoofers with full individual control, set the Input
Function switch for all to the Master position. From the Amplifier, processor or
receiver's subwoofer output, use a Y-connector.

herman

NOTICE
• DO NOT use XLR and RCA connections in parallel for the same connection.

In a setup with multiple subwoofers you can use the XLR connections between the Master
and Slave subwoofers, even if the connection between the processor or receiver has
been made using the RCA connectors.

herman

雙拾真係唔同, 氣氛緊張好多

qq1122yq

雙拾真係唔同, 氣氛緊張好多
herman 發表於 2011-6-17 12:55

    2隻特性唔同雙拾取長補短更過癮...

herman

玩過 mk350, 完全唔鐘思果重粗獷野蠻大舊既聲音

賣左lu

thomas449

ryanenen

玩過 mk350, 完全唔鐘思果重粗獷野蠻大舊既聲音

賣左lu
herman 發表於 2011-6-17 13:27

莫非你鈡意飛机抄落地面d低頻有沉棉花包住既感覺

herman

真係唔鐘意大力比人打心口, 果種感覺係難受...

冇法